Connecting An Scp Card To An Snmp Management System; Connecting The Hub-1 And Hub-2 Lan Ports - Paradyne 8820 Installation Manual

Connecting an SCP Card to an SNMP Management System

Procedure
To connect an SCP card to an SNMP management system:

Connecting the Hub-1 and Hub-2 LAN Ports

The Hub-1 and Hub-2 LAN ports provide a NEBS-compliant hub for applications
that require connecting external devices though the 8820 system. The SCP card
and 8922 POTS card can be monitored using these ports.
Procedure
To connect a Hub port:
8820-A2-GN20-80
1. Plug an 8-pin modular cable into LAN SLOT A or B of the SIM, according to
which slot the SCP card is installed.
2. For a chassis with a redundant SCP card, a cable is required in both the LAN
SLOT A and LAN SLOT B jacks of the SIM.
3. Dress the cable or cables to the right and through the cable retainer.
4. Plug the other end of the cable or cables into the 10/100BaseT hub connected
to the SNMP management system network.
1. Plug an 8-pin modular UTP CAT5 cable into the desired Hub LAN port.
2. Dress the cable(s) to the right and through the cable retainer.
3. Plug the other end of the cable into your external device.
November 2004
5. Cabling: Test Access SIM
5-7