Changing The Setback Position Of The Mounting Brackets - Paradyne 8820 Installation Manual

Changing the Setback Position of the Mounting Brackets

The setback position of the mounting brackets may be changed from the shipped
1-inch setback position to the flush, 3-inch, or 5-inch setback positions by
removing the mounting brackets' three screws, repositioning the mounting
brackets, then reinstalling the three screws.
Procedure
To change the position of the mounting brackets:
8820-A2-GN20-80
1. Remove the screws (three on each side) that hold the mounting brackets to
the chassis.
2. Reposition the brackets for the desired setback (flush, 1-inch, 3-inch, or
5-inch). (Refer to procedures for reversing brackets if installing in a 23-inch
rack in Positioning the Mounting Brackets
3. Replace and tighten the three screws on each side to attach the brackets in
the setback position.
4. Follow the procedures for installing the chassis in a 19- or 23-inch rack in
Installation into a 19-Inch or 23-Inch Rack
November 2004
2. Installation
on page 2-6.)
on page 2-8.
2-7