Filler Plates And Cards For The Bac - Paradyne 8820 Installation Manual

Filler Plates and Cards for the BAC

All circuit cards except the active SCP card or SCM card may be replaced without
disruption to user data (that is, you can remove and reinstall a card without
powering down the chassis and disrupting user data on the other cards). To
remove the card from the base chassis, unfasten the screws on both ends of the
faceplate. Then push both ejector handles outward and slide the card out.
8820-A2-GN20-80
Slot # Is Shipped with . . .
1–7 Two multislot filler plates (left,
covering Slots 1–7, and right,
10–16
covering Slots 10–17)
8 and Single filler plate with receptacle
17 for multislot filler plate edge
9 Single 0.8-inch (2.03 cm) filler
plate with EMI gasket
18 Single 0.8-inch filler (2.03 cm)
plate with EMI gasket
A Single 1-inch (2.54 cm) filler
plates with EMI gaskets
B Single 1-inch (2.54 cm) filler
plates with EMI gaskets
NOTE:
When swapping DSL port cards, it is important to note that in the BAC, the
Media Access Control (MAC) address (also referred to as the physical
address) for each slot is stored in the System Interface Module (SIM). A
replacement DSL port card will be assigned a MAC address for the slot as
stored in the SIM. Replacing the SIM will result in a new MAC address being
assigned to all slots.
November 2004
And Can Accept For Installation
These Cards . . . Instructions, See . . .
Line Card Installing Line Cards into
Slots 1–7 and 10–17
page 2-20
Line Card Installing Line Cards into
Slots 8 and 18
page 2-24, or
Line Cards into Slots 1–7
and 10–17
Line Card or Installing a Line Card into
MCP Card Slot 9 on page 2-24, or
Installing an MCP Card
on page 2-19
Line Card Installing Line Cards into
Slots 8 and 18
page 2-24
SCP Card or Installing an SCP Card
SCM Card on page 2-18 or
an SCM Card
page 2-26
SCP Card Installing an SCP Card
on page 2-18
2. Installation
on
on
Installing
on page 2-20
on
Installing
on
2-17