Paradyne 8820 Installation Manual page 24

2. Installation
In addition, each chassis is shipped with the following:
Be sure to register your warranty at www.paradyne.com/warranty.
Before installing the 8820 BAC, read the
beginning of this document.
2-4
Associated hardware bundled in a plastic bag:
— 4 #10-32 mounting screws
— 4 #12-24 mounting screws and 4 #12-24 self-retaining nuts
(for use with racks without threaded mounting holes)
— 18 large cable bushings for use with the 18 rear-mounted connectors
— 4 small cable bushings
— 5 wire ring tongue terminals for use with the power source wires
— 18 cable ties to attach the Tip and Ring cables to line cards (should
locking pivot brackets not be used)
Additional hardware in a separate plastic bag:
— 18 locking pivot brackets and screws for use with the customer-provided
cables used on the rear of the chassis
November 2004
Important Safety Instructions
8820-A2-GN20-80
in the