Installation Into A Rack Without Threaded Screw Holes - Paradyne 8820 Installation Manual

Installation into a Rack without Threaded Screw Holes

Procedure
To install the chassis in a rack that does not have threaded screw holes:
8820-A2-GN20-80
Front Rail
Front of 19-inch Rack
1. Determine the preferred placement of the chassis in the rack. The chassis is
24.5 inches (62.2 cm) high. The top mounting hole is 1.484 inches (3.77 cm)
from the top of the chassis. Mark the appropriate locations for the machine
screws on the rack.
2. Slip a self-retaining nut onto each rail hole selected and align the hole of the
self-retaining nut with the hole in the rail.
3. Line up the chassis mounting bracket with the self-retaining nut and start to
rotate the self-retaining nut screw into the chassis mounting bracket and the
self-retaining nut. Start all screws, then tighten all screws until each screw
head is flush with the chassis and is securely mounted in the rack.
November 2004
Self-retaining
Nut
Screw
Keyhole
02-15324b-02
2. Installation
2-9