Table of Contents
Advertisement
7. Mixing
The voices of two different Banks (Structures) can
be mixed.
*
Two voices are mixed in the pitches of when
sampled. Recording Key Number or Bank Tune
(See page
59) does not affect the pitches of
sounds.
* The Structure to be mixed should be the same
type. (For instance, the Structure
A and CD
cannot be mixed)
The mixed data can be written into the source
Structure or the same type of Structure. The
voices to be mixed should have the same
sampling frequency. 15 kHz sampling cannot be
properly mixed with 30 kHz.
(Sampling frequency of a wave
data can be
monitored in "Sampling Frequency" on page 67)
Take Step © on page 74, selecting either of the
Structures to be mixed.
Take steps @ and @, selecting "Mix".
Mi
F
The Structure shown in the left of the Display and
the one whose Structure Button is lit are mixed
and rewritten into the Structure shown at the right
of the Display.
When the Structure A, B, C or D is selected (the
indicator on), the Structure (shown at the left of
the
Display)
which
is to be mixed
with the
selected structure can be altered.
82
@ Select the destination Structure (shown at the
right of the Display) by moving the flashing cur-
sor with the ® button and using the Alpha Dial.
@® Push the Enter Button.
SMP CLK
REC KEY
BANK TUNE
SCAN MODE
LOOP
ADRS GROUP
ADRS V-SW
sT1
EN1
LP1
LOOP TUNE1
sT2
EN2
LP2
LOOP TUNE2
ENV V-SENS
ENV RATE1
ENV LEVEL1
ENV RATE2
ENV LEVEL2
ENV RATES
ENV LEVEL3
ENV RATE4
DYN SENS
KEY
FOLLOW
PITCH
BEND
VIBRATO
A-BEND
RATE
A-BEND
DPTH
B
Advertisement
Table of Contents
