Pitch Bend - Roland S-220 Owner's Manual

b. Pitch Bend
[Bend Range]
FITCH BEND
RAMIGE = 2
PROCEDURE
@ Push the F1 Button, then the Performance But-
ton. (Or push the Performance Button twice.)
'ITCH BEND
GE
@ Push the Enter Button.
* The S-220 cannot play a pitch that exceeds the
original sampled sound REC KEY (explained on
page 59) by two octaves. Any higher pitch
(Bend-up) will be substituted by the highest
possible pitch.
* The Bend Range value you have set will be re-
tained in the S-220's memory, but cannot be
retained in the QD.
* If the Bender switch (explained on page 55) in
the Wave Parameter section is set to OFF, the
sound would not take on the pitch bend effect.
* If the MIDI Pitch Bend switch (explained on
page 99) in the MIDI Function section is set to
OFF, the MIDI Pitch Bend messages are igno-
red, therefore, the pitch bend effect cannot be
obtained.
@ Pitch Bend Mode
25