Midi Mode Selection - Roland S-220 Owner's Manual

PROCEDURE
@ Push the Eject Button to remove the protect
sheet.
@® Connect the MIDI OUT connector on the trans-
mitter (controller) to the MIDI IN on the S-220
using the supplied MIDI Cable.
@ Connect the appropriate Output Jack on the
S-220 to the input jack on the amplifier using
the supplied audio cable.
@ Turn on the S-220, transmitter MIDI device
then the amplifier.
When the S-220 is turned on, the Display re-
sponds with:
* If necessary, adjust the contrast of the Dis-
play using the Contrast Knob on the rear
panel.
b. MIDI Mode Selection
The S-220 is released from the manufacturer in
Poly mode as a default. If using the MIDI-Guitar
Converter, change it to the Mono mode as follows
before going to the next section "c, MIDI channel
setting".
PROCEDURE
@ Push any of the Structure Buttons, then the
MIDI Button.
@ Push the Forward or Backward Button to call
"MIDI Mode" in the Display.
@® By rotating the Alpha Dial, change the Display
from "POLY" to "MONO".
@ Push the Enter Button.
The Mono Mode Indicator lights up.
* When the Mono mode command is sent from
an external MIDI device, the S-220 will be set
to Mono mode and the Mono Mode Indicator
will light up. Meanwhile, the S-220 recognizes
how many voices it can output at a time, and
indicates it in the"Channel Range" section. (See
page 91.)
* The MIDI Mode setting is retained in memory
even after the unit is turned off.