Roland S-220 Owner's Manual page 71

© Push the Save Button.
When a brand new QD is used, the data will be
automatically saved onto it.
ge SESE SER Seo
If you wish to retain the data saved on the QD,
make sure the disk drive indicator is dark, push
the Eject Button and take the QD out, then insert
another QD.
Now, push the Save Button.
* To cancel saving, push any Structure Button
When saving is completed, the Display will
change to:
To protect the saved data from any accidental
loss, take the QD out, and snap off the Protect
Nail. (See page 8.)
When more than one Bank is used in a Structure,
the Display will respond as below, This tells you
that you need to save the other Bank to the other
side of the QD.
thane ff
Ture-T
t
Bank that needs saving data
@® As the Display indicates, remove the QD and
reinsert it with the other side facing upward, (or
insert another QD)
Likewise, save all the Banks of the Structure.
When saving is impossible, the following error
messages will be shown.
Error
Weite Frotect
Verify Err
val