Table of Contents
Advertisement
1. Level Adjusting
The volume of the sampled sound in each Bank
can be adjusted.
Take step © on page 74 selecting any Structure
you like.
Take steps @ and ®, selecting "Level Adjust".
6 @ Set the desired level using the Alpha Dial.
* Here, if you push both the Button ® and the
Button <4 at the same time, the maximum level
of the sample is detected and shown in the
Display. This willhelp you set the volume.
® Push the Enter Button.
Levl-—--+
Wait
a
minute ---
The S-220 returns to the Playing mode.
* When the level is set to 100%, each Bank will
be automatically set to the maximum volume
which is the level just before the sound is dis-
torted. However,
some
samples
are distorted
every time they are played. This, however,
does not mean that the Wave Data itself is
distorted.
So, simply set a lower value to
remove the distortion.
When a Split Structure is selected, the volume of
each Bank will become equal to the level set in
the Level Adjusting.
e.g.) Level Adjustment of the Structure AB
'Sample of the Bank A
Sample ofthe Bank B
Ararat ara
BH Level Adjusting
78
Sample of the Bank B
A
'Sample
of the Bank A
100%
To adjust the level of a Bank or Banks of a Split
Structure (e.g. AB/CD), take the following proce-
dure.
1) Simply call the relevant Bank(s) by pushing the
appropriate Structure
Button, then the Enter
Button.
2) Adjust the level of a Bank or group of Banks by
taking steps @ to ©.
3) Return the Bank or the group of Banks to the
Structure it belongs to by pressing the Struc-
ture Button which was selected before you
took step @, then push the Enter Button.
Error
When this error message is indicated, the select-
ed Structure is irrelevant, therefore, cannot be
level-adjusted. Select the appropriate Structure by
pushing the corresponding
Structure Button then
the
Enter
Button.
Then
repeat
the
whole
procedure.
FS
Advertisement
Table of Contents
