Table of Contents
Advertisement
VC-2 MIDI Implementation
❍ Effect 1 (Reverb Send Level) (Controller number 91)
Status
2nd byte
BnH
5BH
n = MIDI channel number: 0H - FH (ch.1 - 16)
vv = Reverb Send Level: 00H - 7FH (0 - 127)
❍ Effect 3 (Chorus Send Level) (Controller number 93)
Status
2nd byte
BnH
5DH
n = MIDI channel number: 0H - FH (ch.1 - 16)
vv = Chorus Send Level: 00H - 7FH (0 - 127)
❍ RPN MSB/LSB (Controller number 100, 101)
Status
2nd byte
BnH
65H
BnH
64H
n = MIDI channel number: 0H - FH (ch.1 - 16)
mm = upper byte (MSB) of parameter number specified by RPN
ll = lower byte (LSB) of parameter number specified by RPN
<<< RPN >>>
Control Changes include RPN (Registered Parameter Numbers), which are
extended.
When using RPNs, first RPN (Controller numbers 100 and 101; they can be sent in
any order) should be sent in order to select the parameter, then Data Entry
(Controller numbers 6 and 38) should be sent to set the value. Once RPN messages
are received, Data Entry messages that is received at the same MIDI channel after
that are recognized as changing toward the value of the RPN messages. In order
not to make any mistakes, transmitting RPN Null is recommended after setting
parameters you need.
This device receives the following RPNs.
RPN
Data entry
MSB, LSB
MSB, LSB
00H, 00H
mmH, llH
00H, 01H
mmH, llH
00H, 02H
mmH, llH
7FH, 7FH
---, ---
● Program Change
Status
2nd byte
CnH
ppH
n = MIDI channel number: 0H - FH (ch.1 - 16)
pp = Program number: 00H - 7FH (prog.1 - prog.128)
2
3rd byte
vvH
3rd byte
vvH
3rd byte
mmH
llH
Notes
Pitch Bend Sensitivity
mm: 00H - 18H (0 - 24 semitones)
ll: ignored (processed as 00H)
Up to 2 octave can be specified in semitone
steps.
Channel Fine Tuning
mm, ll: 20 00H - 40 00H - 60 00H
(-4096 x 100 / 8192 - 0 - +4096 x 100 / 8192 cent)
Channel Coarse Tuning
mm: 10H - 40H - 70H (-48 - 0 - +48 semitones)
ll: ignored (processed as 00H)
RPN null
RPN and NRPN will be set as "unspecified."
Once this setting has been made, subsequent
Data Entry messages will be ignored. (It is not
necessary to transmit Data Entry for RPN Null
settings.)
Parameter values that were previously set will
not change.
mm, ll: ignored
● Channel Pressure
Status
2nd byte
DnH
vvH
n = MIDI channel number: 0H - FH (ch.1 - 16)
vv = Channel Pressure: 00H - 7FH (0 - 127)
● Pitch Bend Change
Status
2nd byte
EnH
llH
n = MIDI channel number: 0H - FH (ch.1 - 16)
mm, ll = Pitch Bend value: 00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
■ Channel Mode Messages
● All Sounds Off (Controller number 120)
Status
2nd byte
BnH
78H
n = MIDI channel number: 0H - FH (ch.1 - 16)
* When this message is received, all notes currently sounding on the
corresponding channel will be turned off.
● Reset All Controllers (Controller number 121)
Status
2nd byte
BnH
79H
n = MIDI channel number: 0H - FH (ch.1 - 16)
* When this message is received, the following controllers will be set to their reset
values.
Controller
Polyphonic Key Pressure
Channel Pressure
Pitch Bend Change
Modulation
Expression
Hold 1
Sostenuto
Pedal 1 Type MSB
Pedal 1 Type LSB
Pedal 2 Type MSB
Pedal 2 Type LSB
Breath Type MSB 0
Breath Type LSB 0
General Purpose Controller 1 MSB
General Purpose Controller 2 MSB
General Purpose Controller 3 MSB
General Purpose Controller 4 MSB
General Purpose Controller 5 MSB
General Purpose Controller 6 MSB
General Purpose Controller 7 MSB
General Purpose Controller 8 MSB
General Purpose Controller 9 MSB
General Purpose Controller 10 MSB
General Purpose Controller 1 LSB
General Purpose Controller 2 LSB
General Purpose Controller 3 LSB
General Purpose Controller 4 LSB
General Purpose Controller 5 LSB
General Purpose Controller 6 LSB
General Purpose Controller 7 LSB
General Purpose Controller 8 LSB
General Purpose Controller 9 LSB
3rd byte
mmH
3rd byte
00H
3rd byte
00H
Reset value
0 (off)
0 (off)
+/-0 (center)
0 (off)
127 (max)
0 (off)
0 (off)
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
(min)
(min)
0 (min)
0 (min)
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min)
0 (min)
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
0 (min) * for V-Synth only
Advertisement
Table of Contents
