Paradyne 1752 SHDSL User Manual page 82

Shdsl routers
Hide thumbs Also See for 1752 SHDSL:
Table of Contents

Advertisement

1752 and 1754 SHDSL Router User's Guide
Option
Df Bit
Bundle Id
Bundle Order
SPI
Self Ipv4Addr
Peer Ipv4Addr
Addr Ver
IPsec SA Stats for
SA
Aut Algo
Enc Algo
82
Df Bit indicates how the Don't Fragment (DF) bit in the IP
header should be be handled in tunnel mode. You can
choose from the following dfbitcfg values:
If copy is set, the DF bit in the outer IP (tunnel) header is
copied from the inner IP header.
If set is set, the DF bit is always set to 1 in the tunnel IP
header. This should only be specified if the SA is a tunnel
mode SA.
If clear is set, the DF bit in the tunnel header will always be
reset.
A unique identifier for each SA that forms part of a bundle. All
SA bundles associated with a policy should have different
bundleids. By default, the bundleid is 0, signifying that the SA
is not part of any bundle or is a single SA.
e.g. 0.
The Bundle Order specifies the location of a particular SA in a
bundle. This is a mandatory parameter if bundleid is
specified. It can take positive integer values. The SA with the
lowest bundleorder value is applied first, followed by the
higher bundleorder value, irrespective of the direction of the
SA.
e.g. 0.
SPI specifies a unique value. If the SA is applicable to
inbound traffic (in), the SPI is assigned by the sender. If the
SA is applicable to outbound traffic (out), the SPI is assigned
by the receiver. This value must be greater than 255 and less
than 65536.
e.g. 300.
The source gateway addresses for IPv4 packets. These are
only specified in tunnel mode.
The destination gateway addresses for IPv4 packets. These
are only specified in tunnel mode.
IPv4 or IPv6. Only IPv4 is currently supported.
statistics about the number of inbound and outbound packets
that match a specific IPsec policy.
Indicates the authentication algorithm used for IPsec
processing. Supported values are md5 and sha1.
e.g. md5
Indicates the encryption algorithm used for IPsec processing.
It can only be specified if the IPsec protocol used is ESP.
Supported values are des and 3des.
e.g. 3des.
June 2005
Description
1752-A2-GB20-00

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1754 shdsl17521754

Table of Contents