Paradyne 1752 SHDSL User Manual page 56

1752 and 1754 SHDSL Router User's Guide
2. Click on Add Global Address Pool. The following page is displayed:
3. This page allows you to create a pool of network IP addresses that are visible outside your
network. Add values for the following table entries:
• Interface type. The internal address type that you want to map your external global IP
addresses to. Click on the drop-down list and select an interface type.
• Use Subnet Configuration. There are two ways to specify a range of IP addresses. You can
either Use Subnet Mask (specify the subnet mask address of the IP address) or Use IP
Address Range (specify the first and last IP address in the range). Click on the drop-down list
and select a method.
• Type in the IP Address that is visible outside the network
• Subnet Mask/IP Address 2. The value you specify here depends on the subnet
configuration that you are using. If you chose Use Subnet Mask, type in the subnet mask of
the IP address. If you chose Use IP Address Range, type in the last IP address in the range
of addresses that make up the global address pool.
4. Once you have configured the table, click on
refreshed and the global address pool is added to your NAT configuration. To delete a global
address pool, click on the Delete hyperlink, then click on the Delete Global Address Pool
button.
56 June 2005
. The table is
1752-A2-GB20-00