Paradyne 1752 SHDSL User Manual page 79

Step 2: Create IPSec Interface
Click on the Create IPSec Interface link, the IPSec Interface page is displayed as follows:
Input the values on the fields respectively. The following table gives the range of values for
each option, which can be specified with this command and a default value.
interface name
ikeport
Status
Note: if to create a IPSec Interface successfully, a new WAN service should be created in
advance via WAN connection page.
Step 3: Create IPSec Policy
If step1 and step 2 are successfully created, the Create IPSec Interface link will appear. Click
on the link, and then the IPSec Interface page is displayed as follows:
Input the values on the fields respectively. The following table gives the range of values for
each option, which can be specified with this command and a default value.
1752-A2-GB20-00
field
Name of the interface
The IKE port value; the UDP port number on
which IKE daemon listens on all valid unicast IPv4
and IPv6 addresses of this interface. The default
value is 500.
The status of IPsec on this interface. The default
value is disabled.
June 2005
1752 and 1754 SHDSL Router User's Guide
Description
79