Cab Tilt Operation - Komatsu GALEO HM350-2 Operation & Maintenance Manual

OPERATION

CAB TILT OPERATION

To prevent serious injury or death if the cab comes down, always observe the following strictly when tilting the cab.
Precautions before performing cab tilt operation
Perform the cab tilt operation on a flat place.
To prevent interference between the cab and machine body when performing the tilt operation, set the machine facing directly
to the front and secure the front and rear frames with the articulation lock.
Set the parking brake switch to the "PARKING" position to apply the parking brake.
Lock the dump control lever with the dump lever lock knob.
Put blocks under the tires to prevent the machine from moving.
Do not perform the cab tilt operation in the strong wind.
Precautions when performing cab tilt operation
Do not operate the cab tilt when the machine is loaded.
Do not stand under the cab during the cab tilt operation.
While the cab is tilted up, fix it with the lock bar securely.
While the cab is tilted up, do not ride on or get off it.
While the cab is tilted up, do not operate the gear shift lever or dump control lever.
Do not start the engine while the cab is tilted up. If it is necessary to start the engine when carrying out inspection, check first
that there is no one under the cab.
Do not subject to the machine to any large impact force while the cab is tilted up.
When lowering the cab by using the tilt cylinder, do not lower the hydraulic pressure at a time but lower it gradually to adjust
the lowering speed of the cab.
The lock bar is set on the right inside of the engine hood. After using it, be sure to return it.
WARNING
OPERATION
3 - 107