Komatsu GALEO HM350-2 Operation & Maintenance Manual page 80

OPERATION
EXPLANATION OF COMPONENTS
STARTING SWITCH
This switch (1) is used to start or stop the engine.
OFF position :
At this position, the starting switch key can be inserted or removed.
When the key is turned to this position, all the electric circuits are
switched off and the engine stops.
ON position :
In this position, electric current flows in the charging and lamp
circuits.
Keep the starting switch key at the ON position while the engine is
running.
When turning the starting switch ON or OFF, if the starting switch
is held at a position between ON and OFF, the controller may
detect this as a problem. If this happens, return the starting switch
to the OFF position, then operate it as usual to the ON position.
In cold weather, if the starting switch is turned to the ON position, pre-heating is automatically started and the engine
pre-heating pilot lamp lights up. After the pre-heating is completed, the engine pre-heating pilot lamp goes out.
START position :
This is the position to start the engine. Hold the key at this position while cranking. Release the key immediately after
the engine has been started. The key will return to the ON position when released.
LAMP SWITCH
This switch (2) lights up the head lamps, side clearance lamps, tail
lamps, machine monitor lighting, and rear lamps.
Position (a): OFF
Position (b): Side clearance lamps, tail lamps, real lamps, and
machine monitor lighting light up
Position (c): Front lamps light up in addition to lamps at position (b)
The lamp switch can be operated regardless of the position of the
lever.
TURN SIGNAL LEVER
This lever (2) operates the turn signal lamp.
(a)Right turn: Push the lever forward
(b)Left turn: Push the lever back
When the lever is operated, the turn signal pilot lamp also flashes.
The lever is automatically returned when the steering wheel is
turned back. If the lever does not return, move it by hand.
3 - 31