Clean Hydraulic Tank Strainer; Clean Transmission Case Strainer - Komatsu GALEO HM350-2 Operation & Maintenance Manual

SERVICE PROCEDURE

CLEAN HYDRAULIC TANK STRAINER

The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature
to go down before starting the operation.
If there is still pressure remaining inside the case, the oil or plug may fly out. Turn the plug slowly to release the pressure, then
remove it carefully.
1. Remove plug (1) of the strainer (2 places) inside the front left
wheel.
2. Take the strainer out from strainer case (2), then wash it in
clean diesel fuel.
3. Assemble the strainer to strainer case (2), then install plug (1).

CLEAN TRANSMISSION CASE STRAINER

The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature
to go down before starting the operation.
If there is still pressure remaining inside the case, the oil or plug may fly out. Turn the plug slowly to release the pressure, then
remove it carefully.
Drain the oil from the transmission case before starting the
operation. For details, see Section "CHANGE OIL IN
TRANSMISSION CASE (PAGE 4-67)".
1. Remove bolt (1), then remove cover (2) and take out the
strainer.
2. Remove any dirt stuck to the strainer, then wash in clean diesel
fuel or flushing oil. If the strainer is damaged, replace it.
3. Install the strainers in their original position.
4 - 80
WARNING
WARNING
MAINTENANCE