Handrails And Steps; Mounting And Dismounting; Crushing Or Cutting Prevention - Komatsu GALEO HM350-2 Operation & Maintenance Manual

GENERAL PRECAUTIONS

HANDRAILS AND STEPS

To prevent personal injury caused by slipping or falling off the machine, always do as follows.
Use the parts marked by arrows in the diagram when getting on
or off the machine.
A: For getting on or off machine using left door
B: For getting on or off machine using right door
To ensure safety, always face the machine and maintain
three-point contact (both feet and one hand, or both hands and
one foot) with the handrails and steps to ensure that you support
yourself.
Do not grip the dump lever when getting on or off the machine.
Never climb on the engine hood or covers where there are no
non-slip pads.
Before getting on or off the machine, check the handrails and
steps, and if there is any oil, grease, or mud on them, wipe it off
immediately. In addition, repair any damage and tighten any
loose bolts.
Do not get on or off the machine while holding tools in your hand.

MOUNTING AND DISMOUNTING

Never jump on or off the machine. Never get on or off a moving machine.
If the machine starts to move when there is no operator on the machine, do not jump on to the machine and try
to stop it.

CRUSHING OR CUTTING PREVENTION

If the clearance at the articulating portion changes, it will lead to serious personal injury.
Do not allow anyone to come inside the articulation range.
The clearance in the area around the dump body changes according to the movement of the dump body. If you
are caught, you will suffer serious injury. Do not allow anyone near any of the rotating or telescoping parts.
2 - 12
SAFETY