Komatsu GALEO HM350-2 Operation & Maintenance Manual page 158

OPERATION
WHEN USING TILT CYLINDER
(If equipped)
1. Remove pin (1) in the mount at the rear of the cab, and insert
it in hole (3).
2. Remove the cab mounting bolts (8 pieces).
3. Apply hydraulic pressure 20.6 to 34.3 MPa (210 to 350 kg/cm
2
, 2980 to 4970 PSI) to hose (4) behind the front right wheel and
raise the cab.
4. After tilting up, fixed the cab in position with lock bar (5).
5. Make sure that lock bar (5) is installed in the correct direction
and lock it securely with lock (6).
6. After returning the cab to its original position, insert pin (1) in
hole (2).
OPERATION
3 - 109