Komatsu GALEO HM350-2 Operation & Maintenance Manual page 132

OPERATION
ADJUSTING MIRROR
Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the visibility and may be
injured or may injure someone seriously.
Loosen mirror securing bolt (1), screw (2) and nut (3) and adjust the
mirror position the way it assures the best view from the operator's
seat.
Adjust the position and angle of each mirror so that it reflects a
sight 200 mm above the ground and up to 1500 mm. In the
adjustment, make sure that part of the dump truck's image also
comes into view.
View Range
Mirror A: Must be possible to see front of machine
Mirror B: Must be possible to see hatched portion (B)
Mirror C: Must be possible to see hatched portion (C)
Mirror D: Must be possible to see hatched portion (D), ground
contact point of tire (D'), and ground surface (D")
Mirror E: Must be possible to see hatched portion (E)
Mirror F: Must be possible to see hatched portion (F), ground
contact point of tire (F'), and ground surface (F")
Rear monitor (if equipped): Must be possible to see hatched
WARNING
portion (G)
OPERATION
3 - 83