Test Run - Grizzly EXTREME Series Owner's Manual

460V Power Connection
Once the 460V voltage conversion beginning on
Page 17 has been completed, refer to the follow-
ing instructions to connect the machine to power.
To connect the machine to power for 460V opera-
tion, move the disconnect switch handle to the ON
position, as illustrated below. The machine is now
connected to the power source.
Figure 22. Connecting power to machine.
To disconnect the machine from the power source,
move the disconnect switch handle to the OFF
position, as illustrated below. The machine is now
disconnected from the power source.
Note: Lock the switch in the OFF position to
restrict others from starting the machine.
Figure 23. Disconnecting power from machine.
-24-

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following: 1)
The power supply polarity is correct, 2) the motor
powers up and runs correctly, 3) the controls work
correctly, 4) the work light turns ON and OFF, and
5) the switch disabling key disables the auxiliary
power properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
2. Connect machine to power (refer to Power
Connection on Page 23).
Note: Do not connect auxiliary power cord to
power until instructed later in Test Run.
Model G0965 (Mfd. Since 04/23)