Assembly; Power Connection - Grizzly EXTREME Series Owner's Manual

Assembly

Before assembling the Model G0965, complete
Steps 1–14 of Test Run on Page 24. The HEPA
filter cannot be installed until the power supply
polarity and safety relief valve have been tested.
Once you have confirmed that these are working
correctly, fully assemble the machine with the
steps below before proceeding with Steps 16–20
of the Test Run.
NOTICE
Do not perform the below assembly steps
until Steps 1–14 of Test Run have been
completed.
To assemble machine:
1. Place HEPA filter in filter cage so air flow direc-
tion arrow points into cage (see Figure 20).
HEPA
Filter
Figure 20. Placing HEPA filter in filter cage.
2. Attach filter cage to machine with (12)
x ⁄ " knob bolts and
3
4
Figure 21).
Note: If drain valve handle is open, it may
interfere with this step.
Model G0965 (Mfd. Since 04/23)
Filter
Cage
Air Flow
Direction
Arrow
⁄ "-20
1
4
⁄ " fender washers (see
1
4
Figure 21. Filter cage attached to machine.

Power Connection

Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the POWER
SUPPLY section in this manual, and all previ-
ous setup instructions in this manual must be
complete to ensure that the machine has been
assembled and installed properly.
NOTICE
The Model G0965 is prewired for 230V. If
you plan to operate machine at 460V, motor
must be rewired, magnetic switch must be
replaced, and machine must be connected
to a hardwired disconnect switch. Use
instructions beginning on Page 17 before
referring to 460V Power Connection section.
230V Power Connection
To connect the machine to power for 230V opera-
tion, install a 15-20 plug on the end of the power
cord per the plug manufacturer's instructions. If no
instructions were included, use the wiring diagram
on Page 46.
Insert power cord plug into a matching power sup-
ply receptacle. The machine is now connected to
the power source.
If you need to disconnect the machine from power
later, pull the plug completely out of the recep-
tacle.
Filter Cage
x 12
-23-