Cleaning/Replacing Canister Filters - Grizzly EXTREME Series Owner's Manual

Cleaning/Replacing
Canister Filters
Remove and clean the canister filters when
the operating pressure on the pressure gauge
exceeds 6 inches of water (inAq). Replace the
filters when cleaning does not improve perfor-
mance.
Always clean the filters outdoors when possible.
However, take special care to avoid contaminating
the environment. When cleaning or replacing the
filters, always inspect them and replace the filters
if ANY damage or tears are found.
IMPORTANT: DO NOT use compressed air to
clean the filters as it will likely cause a large
amount of dust to become airborne and could also
damage the filters.
Wear safety goggles, respirator, and
protective gloves rated for operational
fumes and waste metal type when removing
and cleaning filters. Take care to minimize
amount of dust allowed to become airborne,
and prevent spread onto hands and clothing.
Items Needed
ANSI-Approved Safety Goggles ...................1 Pr.
NIOSH-Approved Respirator ............................. 1
Protective Gloves..........................................1 Pr.
Soft Brush .......................................................... 1
Vacuum Cleaner w/HEPA Filter ......................... 1
Replacement Filters........................... As Needed
To clean/replace canister filters:
1. DISCONNECT MACHINE FROM POWER
AND AIR!
If you have just turned machine OFF, wait
a few minutes for dust inside machine
to settle before proceeding with following
steps.
Model G0965 (Mfd. Since 04/23)
2. Put on personal protective equipment.
3. Pull (2) maintenance door handles to open
maintenance door.
4. Loosen knob shown in Figure 50, then slide
latch plate right.
Figure 50. Location of filter retaining knob and
5.
Rotate pivot frames down, then slide canister
filters out of machine (see Figure 51).
Qty
Pivot
Frames
Figure 51. Pivot frames rotated down to release
Latch Plate
latch plate.
Canister Filter
(1 of 2)
canister filters.
-37-