SECTION 1: SAFETY For Your Own Safety, Read Instruction Manual Before Operating this Machine The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words intended to convey the level of importance of the safety messages.
Page 5
Safety Instructions for Machinery DISCONNECTING POWER SUPPLY. Always APPROVED OPERATION. Untrained operators disconnect machine from power supply before can be seriously hurt by machinery. Only allow servicing, adjusting, or changing cutting tools trained or properly supervised people to use (bits, blades, cutters, etc.). Make sure switch is machine.
additional safety instructions for Jointers Jointer KicKbacK. "Kickback" is when maXimum cutting depth. the maxi- the workpiece is thrown off the jointer table mum cutting depth for one pass is ⁄ ". by the force of the cutterhead. Always use never attempt any single cut deeper than push blocks and safety glasses to reduce this!
additional safety instructions for planers instruction manual. this machine cutting limitations. the planer may presents significant safety hazards to kick out a workpiece at the operator or be untrained users. read/understand this entire damaged if pushed beyond these limits. manual before starting the planer. •...
section 2: circuit reQuirements 220v operation power connection device the type of plug required to connect your machine to power depends on the type of service you cur- rently have or plan to install. We recommend using the plug shown in figure 1. electrocution or fire could result if machine is not GROUNDED...