Opening Side Doors - Grizzly EXTREME Series Owner's Manual

To operate downdraft table:
1.
Put on personal protective equipment required
by operation.
2.
Place workpiece on table. Unlatch side doors
if workpiece extends beyond table surface.
3. Attach hand-held electric tool to auxiliary
power outlet or air tool to quick-connect
coupler.
4. Turn downdraft table and compressed air
supply ON.
5. Turn ON work light and auxiliary outlet power
if needed for operation.
6. Perform operation.
7. Turn downdraft table and auxiliary power
OFF when operation is finished.
8. Use air pulse system to clean canister filters.
9. Allow downdraft table to run for a few minutes
to collect residual fumes from environment.
10. DISCONNECT MACHINE FROM AIR AND
POWER!
11. Open drain valve to drain any condensation
from air tank and components.
12. Close drain valve.
13. While wearing safety goggles, protective
gloves, and NIOSH-approved respirator rated
for waste metal type, empty dust drawer and
tray.
14. Inspect compartments for fire hazards and
smoldering combustibles before leaving
downdraft table unattended.
-28-

Opening Side Doors

Open one or both of the side doors in order to
accommodate larger workpieces. Close the doors,
when possible, to better direct sparks, fumes, and
dust into filter compartments of the table.
Opening Side Door
1. Unlatch (2) side door latches (see Figure 31).
2.
Lift spring plunger out of table in order to
swing door out (see Figure 31).
Spring
Plunger
Side Door
Latches
Figure 31. Location of side door components.
Closing Side Door
1. Lift spring plunger, swing door closed, then
lower plunger into table (see Figure 31).
2.
Latch (2) side door latches to secure (see
Figure 31).
Model G0965 (Mfd. Since 04/23)