Compressed Air Supply - Grizzly EXTREME Series Owner's Manual

Compressed Air
Supply
The Model G0965 features a quick-connect plug
for attaching a compressed air supply. When the
compressed air is connected, the AIR PULSE
CLEAN button can be used to pneumatically clean
the canister filters. This table also has a coupler
for attaching an air tool to the same air supply. For
constant use of these features, keep the air sup-
ply connected unless you need to switch air tools,
or perform maintenance or service.
When attaching an air supply, use only clean, dry
compressed air. For best results, use an in-line air
regulator and filter setup similar to the one shown
in Figure 33. An in-line regulator will allow you to
adjust the pressure of the air supply down to the
required operating pressure of 90 PSI.
Air escaping through fittings can project
debris into eyes and is extremely loud.
Wear safety glasses and hearing protection
when handling pressurized air system.
In-Line
Air/Moisture
Filter
Air
Compressor
Figure 33. Typical compressed air supply setup for downdraft table and optional air tool.
Model G0965 (Mfd. Since 04/23)
Quick-Connect
Coupler
Regulator
Both the air input and air output connections are
industrial-style quick-connect fittings with a
coupling size. This means the air inlet plug has a
plug tip diameter of ⁄
5
16
⁄ " (see Figure 32). The coupler you attach to
3
16
this plug must also be industrial-style (or univer-
sal) and have a coupling size of
fully seat in it.
Diameter
Figure 32. Measuring industrial-style plug
coupling size.
The downdraft table coupler will require you to
attach an air tool with a hose fitted with the same
size of industrial-style plug with a hose diameter
and thread size of your choosing.
Downdraft
Table
" and a plug tip length of
⁄ " for the plug to
1
4
Length
Air Tool
Hose
w/Plug
-29-
⁄ "
1
4