Test Run - Grizzly T33926 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the control panel works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
For the following Test Run steps, refer to Figure 20.
Readout
Variable-
Speed
Adjustment
ON/OFF
Dial
Button
Figure 20. Readout illuminated.
Model T33926 (Mfd. Since 08/23)
To test run machine:
1.
2.
3.
4.
5.
6.
7.
Forward
Feed
Direction
Button
Set
8.
Button
Reverse
Feed
Direction
Button
9.
Clear all setup tools away from machine.
Adjust and lock power feeder so rollers are
held approximately 1" above machine table
and nothing will interfere with roller rotation.
Connect power feeder to power supply.
Press ON/OFF button. Digital readout will
illuminate.
Press SET button, and use variable-speed
adjustment dial to select 10 FPM on readout.
Number will flash for 10 seconds, then glow
steadily.
Press forward feed
( ), then press and hold variable-speed
adjustment dial until you hear a beeping sound
and outside edge of panel glows red. Motor
should run smoothly and without unusual
problems or noises. Rollers should rotate in a
counterclockwise direction (when viewed from
top).
— If motor or rollers do not function cor-
rectly, disconnect from power and refer to
Troubleshooting on Page 28 before
completing Test Run.
Press variable-speed adjustment dial. Rollers
should stop rotating.
— If rollers stop rotating, variable-speed
adjustment dial is functioning correctly.
Proceed to Step 8.
— If rollers do not stop rotating, variable-
speed adjustment dial is NOT function-
ing correctly. Contact Grizzly Technical
Support before proceeding with Test Run.
Press reverse feed
( ), then press and hold variable-speed
adjustment dial until you hear a beep and
control panel glows red. Rollers should rotate
in clockwise direction (when viewed from top).
Press variable-speed adjustment dial to stop
rollers.
Test Run is complete.
direction button
direction button
-19-