Test Run; Recommended Adjustments - Grizzly G0526A40 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the OFF button works correctly.
Serious personal injury could occur from
connecting machine to power before
completing the setup process described in
this manual. DO NOT connect power until
instructed to do so later in this manual.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine.
2.
Connect machine to power supply.
3.
Press OFF button in, then twist it clockwise
so it pops out. OFF button is reset and ready
for operation (see Figure 27).
-22-
OFF Button
Figure 27. Resetting OFF button.
4. Turn machine ON, verify motor operation,
then press OFF button to turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
5.
WITHOUT resetting OFF button, press ON
button. Machine should not start.
— If machine does not start, OFF but-
ton safety feature is working correctly.
Congratulations! Test run is complete.
— If machine does start, immediately stop
machine. OFF button safety feature is
not working correctly. This safety feature
must work properly before proceeding with
operations. Contact Grizzly Tech Support.
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
• Cutterhead Inserts (Page 38).
• Depth Scale Calibration (Page 40).
• Fence Stop Accuracy (Page 42).
• Table Parallelism (Page 45).
Model G0526A40 (Mfd. Since 12/22)