Test Run - Grizzly G0718 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
To test run the machine:
1.
Read and follow the safety instructions at the
beginning of the manual, and make sure the
machine is setup properly.
2.
Make sure all tools and objects used during
set up are cleared away from the machine.
3.
Verify that the machine is operating correctly
by turning it ON.
—When operating correctly, the machine
runs smoothly with little or no vibration,
rubbing, or grinding noises. Check to make
sure that all chucks rotate. If they do not
rotate, call Tech Support for help.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
4. Turn the machine OFF.
5. Insert the switch disabling pin through the
green ON button, as shown in Figure 23.
-20-
Figure 23. Switch disabling pin installed.
6. Press the green ON button to test the dis-
abling feature on the switch.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Model G0718 (Mfd. Since 12/10)