Test Run - Grizzly G0731 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, 2) the
spindle switch works correctly, and 3) the power
feed controls work correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 37.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
NOTICE
Complete the Initial lubrication procedures
on Page 20 before proceeding. Failure to
follow reasonable lubrication practices as
outlined in this manual could lead to pre-
mature failure of your mill and will void the
warranty.
Model G0731 (Mfd. Since 01/17)
Machine Test Run
1.
Clear all setup tools and loose objects away
from the machine.
2.
Make sure the spindle is lubricated (refer to
Initial Lubrication on Page 20 for detailed
instructions).
3.
Ensure the spindle switch is in the OFF posi-
tion.
4.
Connect the machine to the power supply.
5.
Verify that the machine is operating correctly
by turning the spindle switch to the FWD
position.
— When operating correctly, the machine
runs with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
6.
Turn the spindle switch to the OFF position.
7.
Turn the spindle switch to the REV position.
— When operating correctly, the machine
runs with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
-21-