Advertisement
Safety Instructions
WARNING
4.
- Prevent Electrocution. Do not connect any auxiliary components (for example cable, additional speakers,
headphones, additional audio/video components, etc.) to the system.
5. These units are not provided with an outdoor antennae; when provided, it should be installed in accordance with Article 810
of the U.S. National Electrical Code, ANSI/NFPA 70.
6. Do not service this product yourself as opening or removing covers may expose you to dangerous voltage or other risk of
injury. Refer all servicing to qualified service personnel.
7. When the power supply connection or power supply cord(s) are damaged; if water is entering the audio/video compartment
or any electrical equipment compartment area; if the protective shields or barriers are showing signs of deterioration; or if there
are signs of other potential damage to the unit, turn off the unit and refer servicing to qualified service personnel.
8. This unit should be subjected to periodic routine maintenance (for example, once every 3 months) to make sure the unit is
operating properly.
ADDITIONAL SAFETY CONSIDERATIONS
•
Install the hot tub spa to provide drainage for compartments of electrical components.
•
For floor recessed spas: Install to permit access for servicing from above or below the floor. Hot tub spa equipment must be
installed below water level.
•
When planning your spa installation site, prepare for the unlikely event of rapid spa drainage.
•
Do not place spa in direct sunlight while unit is empty or when sealed in shipping materials. Excessive heat build may
cause damage to spa and void warranty.
•
When installing hot tub spa, allow ample space for future servicing, noting location of all support equipment per the model
specifications.
SAVE THESE INSTRUCTIONS
6
Advertisement
