Advertisement
Operation Systems, Luxury Series | SmartTouch™ Control
Fault Log
The Fault Log is a record of the last 24 faults that can be reviewed by a service tech. Use the Up and Down buttons to view each of
the Faults. When Priming Mode shows in the Fault Log, it is not a fault. Rather, it is used to keep track of spa restarts.
GFCI Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installation.
CE registered systems do not have an RCD Test Feature due to the nature of the electrical service. The end-user must be trained
how to properly test and reset the RCD.
Reset Button
Only use the Reset Button prior to moving the spa to a new location.
Pressing the Reset the button forces a new Test to be performed at the new location.
It is mandatory to verify proper installation and function of the GFCI or RCD. Users /
owners are to manually test this safety device prior to each use. Should the device not
function properly, shut the hot tub off at the breaker and contact service tech.
Units Screen
The Units Icon
on the Settings Screen takes you to the Units Screen.
1.
Press "Temp Display" to change the temperature between Fahrenheit and Celsius.
2.
Press "Time Display" to change the clock between 12 hr and 24 hr display.
Reminders
The Reminder Icon
on the Settings Screen takes you to the Reminders screen. Press
"Reminders" to turn the reminder messages (like "Clean Filter") ON (Yes) or OFF (No).
Clean-Up Cycle
Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available,
set the length of time Pump 1 will run after each use. 0-4 hours are available. Settings it to
0.0 Hr keeps the Cleanup Cycles from running.
The Cleanup Icon
on the Settings Screen takes you to the Cleanup Cycle screen.
Language
The Language Icon
on the Settings Screen takes you to the Language screen. Change
the language displayed on the panel.
42
Advertisement
