Advertisement
Operation Systems, Premium Series | ProView™ Control
The settings have been reset (Persistent Memory Error)* – M021
Contact your dealer or service organization if this message appears on more than one power-up.
The clock has failed* – M020
Contact your dealer or service organization.
Configuration error (Spa will not Start Up)
Contact your dealer or service organization.
The GFCI test failed (System Could Not Test the GFCI) – M036
(North America Only) May indicate an unsafe installation. Contact your dealer or service organization.
A pump may be stuck on – M034
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
Hot fault – M035
A Pump Appears to have been Stuck ON when spa was last powered. POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
Reminders
General maintenance helps.
Reminder Messages can be suppressed by using the Preferences Menu.
Clean the filter
May appear on a regular schedule, i.e. every 30 days. Clean the filter media as instructed by the
manufacturer.
Test the GFCI (or RCD)
May appear on a regular schedule, i.e. every 30 days.
The GFCI or RCD is an important safety device and must be tested on a regular basis to verify its reliability. Every user should be
trained to safely test the GFCI or RCD associated with the hot tub installation. A GFCI or RCD (European) will have a TEST and RESET
button on it that allows a user to verify proper function.
Change the water
May appear on a regular schedule, i.e. every 90 days. Change the water in the spa on regular basis to maintain proper chemical
balance and sanitary conditions.
Change the filter
May appear on a regular schedule, i.e. every 30 days. Filters should be replaced regularly to maintain proper spa function and
sanitary conditions.
52
Advertisement
