Advertisement
Operating System, LifeStyle Series | Accent™ Control
Show and Set Time of Day
Setting the time-of-day can be important for determining filtration times and other background features. When in the TIME menu,
SET TIME will flash on the display if no time-of-day is set in the memory.
Setting Time:
1) Repeatedly press menu key until set time or time appears on screen.
2) Press up or down arrow to adjust hour.
3) Press menu key to switch to minutes.
4) Press up or down key to adjust minutes.
5) Press menu key to exit.
If power is interrupted to the system, Time-of-Day is not stored. The system will still operate and all other user settings will be
stored. If filter cycles are required to run at a particular time of day, resetting the clock will return the filter times to the actual
programmed periods.
When the system starts up, it defaults to 12:00 Noon, so another way to get filter times back to normal is to start up the spa at
noon on any given day. SET TIME will still flash in the TIME Menu until the time is actually set, but since the spa started at noon,
the filter cycles will run as programmed.
Restricting
The control can be restricted to prevent unwanted use or temperature adjustments. Locking the panel prevents the controller
from being used, but all automatic functions are still active.
Locking the Temperature allows Jets and other features to be used, but the Set Temperature and other programmed settings
cannot be adjusted. Temperature Lock allows access to a reduced selection of menu items. These include Set Temperature, FLIP,
LOCK, UTIL, INFO and FALT LOG. Unlock sequence may be used from any screen that may be displayed on a restricted panel.
Lock Panel
1) Press menu key until Lock appears.
2) Press up key, temp will be displayed.
3) Press menu button, panel will be displayed.
4) Press up key twice, ON will be displayed.
5) Press menu button to lock panel.
Lock Temp
1) Press menu key until Lock appears.
2) Press up key for temp lock.
3) Press temp button again.
4) Press temp button to ON.
5) Press menu button to exit.
Hold
Hold—M037*
Hold Mode is used to disable the pumps during service functions like cleaning or replacing the filter. Hold Mode will last for 1 hour
unless the mode is exited manually.
Set Hold:
1) Press menu key repeatedly until hold is displayed.
2) Press up arrow to enter hold.
3) Press down arrow to exit hold.
Unlock Panel
1) Press menu.
2) Press and hold up key.
3) Press menu button twice to unlock.
Unlock Temp
1) Press temp button until Lock appears.
2) Press up key, temp will be displayed.
3) Press and hold up key button.
4) Press menu button twice.
56
Advertisement
