Advertisement
Operation Systems, Premium Series | ProView™ Control
Additional Settings
Reminders
Helpful Maintenance messages that may appear periodically.
Hold: Used to display the pumps during service functions like cleaning or replacing the filter. Hold mode will last for 1 hour unless
exited manually. If the spa service will require more than 1 hour, it is best to shot power off to spa.
Units: Specify time and temperature units.
Panels: Set how long it takes the panel to go to sleep after the last activity. Default is 30 minutes.
Turn on/off the panel lights.
Control the brightness of both the panel lights and the panel display together.
Cleanup: Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available, set the length of time Pump 1
will run after each use. 0-4 hours are available.
Color: Pressing the Select Button when Color is highlighted will cycle through 5 background colors available in the control.
Language: Select language.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature, then the water devices automatically activate to
provide freeze protection. The water devices will run either continuously or periodically depending on conditions.
GFCI Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installation.
CE registered systems do not have an RCD Test Feature due to the nature of the electrical service. The end-user must be trained
how to properly test and reset the RCD.
It is mandatory to verify proper installation and function of the GFCI or RCD. Users / owners are to manually test this safety
device prior to each use. Should the device not function properly, shut the hot tub off at the breaker and contact service tech.
Panel Messages
Most messages and alerts will appear at the bottom of the normally used screens. Several alerts and messages may be displayed
in a sequence. Some messages can be reset from the panel. Messages that can be reset will appear with a "right arrow" at the
end of the message. This message can be selected by navigating to it at pressing the Select button.
Possible freezing condition
A potential freeze condition has been detected, or the Aux Freeze Switch has closed. All water devices are activated. In some
cases, pumps may turn on and off and the heater may operate during Freeze Protection. This is an operational message, not an
error indication.
50
Advertisement
