Advertisement
Operation Systems, Premium Series | ProView™ Control
49
Adjusting
Main Filtration
Using the same navigation and adjustment as Setting the Time, Filter Cycles are set using a start time and a duration. Each setting
can be adjusted in 15-minute increments. The panel calculates the end time and displays it automatically.
Filtration and Ozone
Pump 1 low and the ozone generator will run during filtration.
The system is factory-programmed with one filter cycle that will run in the evening (assuming the
time-of-day is properly set) when energy rates are often lower. The filter time and duration are
programmable.
A second filter cycle can be enabled as needed.
At the start of each filter cycle, the water will run briefly to purge the plumbing to maintain good
water quality.
Filter Cycle 2 - Optional Filtration
Follow the same process to change the other filter time settings, if desired.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by the
overlap amount.
Clean-up Cycle (optional)
When a pump is turned on by a button press, a clean-up cycle begins 30 minutes after the pump is turned off or times out.
The pump and the ozone generator will run for 30 minutes or more, depending on the system.
Purge Cycles
In order to maintain sanitary conditions, as well as protect against freezing, secondary water devices will purge water from their
respective plumbing by running briefly at the beginning of each filter cycle.
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when Filter Cycle 2 is to begin.
Invert Panel
Selecting Invert Panel will flip the display and the buttons so the panel can be easily operated from inside or outside the hot tub.
Restricting Operation
The control can be restricted to prevent unwanted use or temperature adjustments. Locking the Panel prevents the controller from
being used, but all automatic functions are still active. Locking the Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted. Settings Lock allows access to a reduced selection of menu
items. These include Set Temperature, Invert, Lock, Utilities, Information and Fault Log. They can be seen, not changed or edited.
Locking & Unlocking
1) Navigate to Locks.
2) Press the select navigation button to view lock screen.
3) Navigate to either Settings or Panel.
4) Press and hold the Select button for 5 seconds.
5) Follow the same steps to Unlock.
Advertisement
