Advertisement
Electrical Guidelines (60Hz) North America
All installations and connections are to be performed by a qualified, licensed electrician only
and in accordance with the National electric code and all applicable local regulations.
Ensure power is turned off prior to making any electrical connections.
All hot tub units must be installed with a Class A 50 Amp Ground Fault Circuit Interrupter
!
(not supplied) in accordance with the National Electric Code and all applicable local codes.
Installation of GFCI varies among those manufacturers. Follow each manufacturer's
WARNING!
guidelines to ensure proper operation and protection of spa occupants.
Correct wiring of the electrical service box, GFCI and pack terminal block is essential.
*If connected to a 3 wire system, no 240V component will operate.
•
To install the wiring for the spa equipment controller, a Phillips screwdriver and a flat
screwdriver will be needed.
•
Loosen the 3 screws of the spa pack lid and open it. Remove 70 mm (3") of cable
insulation. Strip away 25 mm (1/2") of each wire insulation.
•
Pull the cable through the cutout of the box and use an IEC certified plastic bushing that
will maintain the IPX5 rating.
•
The power cord must be in accordance with the national electrical code of the country in
which it's to be installed and must maintain IPX5 rating. Make sure that only the uncut
sheathing is clamped at this opening.
•
Push the color-coded wires into the terminals as indicated on the sticker, use the flat
screwdriver to tighten the bolts on the terminals.
•
After making sure wire connections are secure, push them back into the box and close
the lid.
•
Tighten the 3 screws of the spa pack lid.
FOR QUALIFIED ELECTRICIAN REFERENCE ONLY!
ATTENTION ELECTRICIAN:
IMPORTANT:
6 Gauge Copper Wire MUST Be Used.
Never use Aluminum Wire!!
Test GFCI Monthly and Prior to Each Use.
Contacting a qualified electrician may be necessary.
240V (4 wires)
G
N
L1
L2
32
Advertisement
