Advertisement
Operating System, LifeStyle Series | Accent™ Control
57
Adjusting
Main Filtration
Filter cycles are set using a start time and a duration. Start time is indicated by an "A" (AM) or "P" (PM) in the bottom right corner of
the display. Duration has no "A" or "P" indication. Each setting can be adjusted in 15-minute increments. The panel calculates the
end time and displays it automatically.
Set Filter Cycle 1:
1) Repeatedly press menu key until FLTR appears.
2) Press up arrow and BEGN will be displayed.
3) Press up arrow again and then use up or down arrow to select filter cycle start time.
4) Press menu key twice to exit beginning time.
5) Press up menu to select run hours then press up arrow or down arrow to hour.
6) Press menu key twice to exit.
Filter Cycle 2
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by the overlap amount. Filter Cycle 2 is
OFF by default.
Set Filter Cycle 2:
1) Repeatedly press menu until FLTR2 appears
2) Press up arrow.
3) Press up arrow again to turn on.
4) Repeat step for setting filter 1.
Purge Cycles
In order to maintain sanitary conditions, pump will purge water from plumbing by running briefly at the beginning of each filter
cycle.
If Filter Cycle 1 is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when Filter Cycle 2 is programmed to begin.
Preference
F/C (Temp Display)
Change the temperature between Fahrenheit and Celsius.
12/24 (Time Display)
Change the clock between 12 hr. and 24 hr. display.
RE-MIN-DERS (Reminders)
Turn the reminder messages (like "Clean Filter") On or Off.
CLN-UP (Cleanup)
Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available, set the length of time Pump 1 will run
after each use. 0-4 hours are available.
Utilities
A utilities menu selection may be accessed and is intended for qualified service techs only.
GFCI Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installation. (The GFCI Test Feature is not available on CE rated systems.)
Advertisement
