Download Print this page

PDC spas Luxury Series Owner's Manual page 40

Hide thumbs Also See for Luxury Series:

Advertisement

Operation Systems, Luxury Series | SmartTouch™ Control
37
Settings Screen
Heat Mode—Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is known as
the "heater pump."
The heater pump is a 2-Speed Pump 1, Ready Mode will circulate water every 1/2 hour, using Pump 1 Low, in order to maintain a
constant water temperature, heat as needed, and refresh the temperature display. This is known as "polling."
Rest Mode will only allow heating during programmed filter cycles. Since polling does not occur, the temperature display may not
show a current temperature until the heater pump has been running for a minute or two.
When the heater pump has come on automatically (for example for heating) you can switch between low speed and high speed but
you cannot turn the heater pump off.
Ready-in-Rest Mode
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1 Button is pressed. When the heater pump has
come on automatically (for example for heating) you can switch between low speed and high speed but you cannot turn the
heater pump off. After 1 hour, the System will revert to Rest Mode. This mode can also be reset by selecting the Heat Mode line.
Settings
Programming, Etc.
The Settings Screen is where all programming and other spa behaviors are controlled.
Each icon on the Settings screen takes you to a different screen, where one or more setting may be viewed and/or edited.
The Heat Icon
takes you to a screen where you control the Heat Mode and the Temperature Range.
Dual Temperature Ranges (High vs. Low)
This system incorporates two temperature range settings with independent set temperatures. The specific range can be selected on
the Settings screen and is visible on the Main Screen in the upper left corner of the display.
These ranges can be used for various reasons, with a common use being a "ready to use" setting vs. a "vacation" setting. Each range
maintains its own set temperature as programmed by the user. This way, when a range is chosen, the spa will heat to the set
temperature associated with that range.
High Range can be set between 80°F and 104°F. Low Range can be set between 50°F and 99°F. Freeze Protection is active in either
range.

Advertisement

loading