Advertisement
Operation Systems, Luxury Series | SmartTouch™ Control
Time-of Day
Be sure to set the Time-of Day
Setting the time-of-day is important for determining filtration times and other background features. The Heat Icon
Settings Screen takes you to a screen where you control the Time-of-Day.
On the Time-of-Day screen, simply select the Hours and Minutes. Use the Up and Down Buttons to make changes, then Save. If no
time-of-day is set in the memory an Information Screen will appear. If you exit it and Information Icon will appear at the bottom of
the Main Screen, until the time-of-day has been set. NOTE: If power is interrupted to the system, Time-of-Day will be maintained
for several days.
Adjusting
Main Filtration
Using the same adjustment as Setting the Time, Filter Cycles are set using a start time and a duration. Each setting can be adjusted
in 15-minute increments. The panel calculates the end time and displays it automatically. The Filter Icon
Screen takes you to a screen where you control the Filter Cycles.
Filter Cycle 2 - Optional Filtration
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2. Press "2" again to turn Filter 2 ON or OFF.
When Filter Cycle 2 is ON, it can be adjusted in the same manner as Filter Cycle 1.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by the overlap amount.
Main Filtration
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
*For example, if your spa is set up for 24/hour circulation except for shutting off when the water temperature is 3˚ F /1.3˚ C above the
set temperature, that shutoff does not occur during filter cycles.
Viewing Filter 1 while Filter 2 is OFF
on the Settings
Viewing Filter 1 while Filter 2 is ON
38
on the
Advertisement
