Table of Contents
Advertisement
INSTALLING THE STOPPER
ASSEMBLY.
1) Using a modeling knife, carefully cut
of the rear portion of one of the 3 nylon
tubes leaving 1/2" protruding from the
rear of the stopper. his will be the fuel
pick up tube.
Trim and cut.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
.
Switch.
INSTALLING THE ENGINE SWITCH.
Trim and cut.
A
Switch.
15
Advertisement
Table of Contents
