Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
30.8
Action
"
"
Menu
Scroll to menu H8.
↲
"
"
Scroll to menu S7.
↲
"
"
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
Synchronize the control units (H8/S7)
After any control unit restart, synchronization will start automatically.
Synchronization can also be started via EBLWin and via this menu
(H8/S7).
The control units have to be synchronized when the following fault
message is shown:
During the synchronization there will be information displayed for all
control units in the system.
↻ (rotating clockwise) = Synchronization in progress for the
control unit (CU) respectively.
√
= Synchronization completed successfully for the control unit
(CU) respectively.
<Blank> = Synchronization failed for the control unit (CU)
respectively.
Text in display
H8 Maintenance
S1 Dis- / Re-connect loop / zone line input
S2 Acknowledge SERVICE signal
S3 Clear weekly average
S4 Test of alarm devices
S5 Safe shut down of control unit
S6 Activate address in alarm mode
S7 Synchronize the control units
S8 Activate / Reset outputs
S7 Synchronize the control units
Start synchronization?
To be continued on the next page.
FAULT: Control unit xx has wrong information.
No
Yes
148
Comments
According to chapter
"Access", see page 88.
Press "▼", to select "Yes".
↲
"
"
Press
to start the
synchronization.
Advertisement
Table of Contents
