Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
Rev: -
7.5
7.6
7.7
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
User level 3A
After the door has been opened with the fire brigade key ("Door open"
symbol
in the symbol area), the service / maintenance personnel
have access to level 2A and after log on as "Service personnel" (level
3A), access to all menus, i.e. like level 2C and also to the following
menus:
Same menus as in access level 2C plus the following:
H5 Service
A1 Calibration of supervised outputs
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in control unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
A7 Activate address setting mode for DU
A8 Setup wireless detectors
A9 SSD information
H8 Maintenance
S1 Dis- / Re-connect loop / zone line input
S2 Acknowledge SERVICE signal
S3 Clear weekly average
S4 Test of alarm devices
S5 Safe shut down of control unit
S6 Activate address in alarm mode
S7 Synchronize the control units
S8 Activate / Reset outputs
H10 Change password (In this case for "Service personnel".)
Access level 3B
Used by Service / maintenance / commissioning engineers when a PC
(i.e. EBLWin) is to be connected to EBL512 G3 for backup (upload),
download of site specific data (SSD) and/or download of software.
EBLWin require an EBLWin key (5094) to be plugged in the PC.
Access level 4
Used by manufacturer or by personnel authorised by the manufacturer
for re-initialisation (reset) of the alarm counter, change software
30
Advertisement
Table of Contents
