Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
27.1
Action
"
"
Menu
Scroll to menu H5.
↲
"
"
↲
"
"
↲
"
"
"
"
ESC
Rev: -
Calibration of supervised outputs (H5/A1)
Supervised (monitored) outputs
The voltage outputs (S0-S3) in each control unit.
The voltage outputs (VO0-VO1) in the COM loop output unit 3364.
The voltage outputs (0-2) on the I/O exp. boards 4583 and 4583DE.
When all alarm devices (sounders, etc.) have been connected,
including required end-of-line devices
downloaded, a calibration has to be done.
Function: If the actual value at any time differs from the calibrated
value ± a small tolerance or if the calibrated value is outside the
calibration range, a fault will be generated.
Text in display
H5 Service
A1 Calibration of supervised output
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in control unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
A7 Activate address setting mode for DU
A8 Setup wireless detectors
A9 SSD information
Start calibration of supervised outputs
↲
(press
)
Calibration completed successfully
A1 Calibration of supervised outputs
NOTE! After the calibration it is recommended do a "Safe shutdown
of the control unit" (see menu H8/S5, page 144). This will save the
SSW data (e.g. the calibration values) in a Flash ROM.
52
Control unit outputs S0-S3: One end-of-line resistor (33K) in the last
unit or one resistor (33K) in up to five units. NOTE! For EN54-13
compliance: One 1K resistor only. 4583 outputs 0-1: Calibration value
range 1K-50K. 4583DE outputs 0-1: Calibration value range 200-1000
ohm. 3364 outputs (VO0-VO1): One end-of-line capacitor (470 nF) in the
last unit or one capacitor (470 nF) in up to five units.
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
120
52
and when the SSD is
Comments
According to chapter
"Access", see page 88.
√
Calibration is ready.
Scroll to another menu or
press "
ESC
".
Advertisement
Table of Contents
