Table of Contents
Advertisement
S T E P 1 2
Assemble Forward Pivot Cover Sets
Figure 22: Locate the Forward Pivot Cover Sets,
noting Right and Left markings.
Using the Step 12 Hardware Kit fully tighten
4 × Phillips Screws on each side using the Phillips
Screwdriver.
TIP: To gain better access to the screw holes
during assembly, carefully adjust the position
of the Linkage by pushing forward or pulling
backward on the Handle Support Tubes.
S T E P 1 3
Figure 23: Locate the Handles, noting Right and
Left markings.
Open the Handle Cam Locks and insert the
Handles while aligning the groove with the arrow
on the bottom of the opening.
Once in the desired position, close the Handle
Cam Locks.
NOTE: Refer to User Guide for more information
on Handle positions.
Step 12 Hardware
Figure 22
Figure 23
13
Advertisement
Table of Contents
