Teeter FreeStep LT7 Get Started page 10

Recumbent cross trainer
Table of Contents

Advertisement

Figure 10
FCC COMPLIANCE NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
S T E P 5
FIGURE 4
Figure 11
8
Connect the Console Wire
Figure 10: Connect the Console Wire between
the Console Post and Console Support Bar.
Connect the Power Adapter to the Base (refer to
Page 14). Temporarily plug into a power source.
To enable you to move the Linkage as needed in
the remaining steps, you will need to disengage
the Step Lock. Press and hold the Lock button on
the Console for 5 seconds.
Once the Console shows UNLOCKED and the
Linkage moves freely, unplug the Power Adapter
from the wall until assembly is complete.
Assemble Console Support Cover Set
Figure 11: Attach the Console Support Cover Set
using 5 × Screws from the Step 5 Hardware Kit,
taking care not to pinch the Console Wire. Fully
tighten with the Phillips Screwdriver.
Step 5 Hardware

Advertisement

Table of Contents
loading

Table of Contents