Heat Management; Heat Produced By Selected Components And Systems; Heat Production Of Selected Systems - Xerox DocuTech 6100 Install Manual

Select and prepare an installation site

Heat management

Heat produced by selected components and systems

Table 4-6. Heat dissipation for the DocuTech printer and devices
Device
Controller (Sun workstation)
Monitor
DocuTech printer (processor, interposer, finisher, and
binder)
4-16
The DocuTech system produces significant amounts of heat
when running in a production environment. The heat produced
by the system must be planned for when selecting a suitable
location for the system.
This section contains the Heat Management Worksheets that
should be completed if you have a DocuTech. It also includes the
tables and figures that are used to complete the Heat
Management Worksheets.
The table below lists the amount of heat produced by some of
the devices included as part of the DocuTech system.
Refer to the following sections for instructions on ways to
calculate and handle the heat produced by the system.

Heat production of selected systems

The following table lists the heat output (BTU per hr.) for the
Xerox 9900, 5090, 9700, and 9500 copiers, and for the Eastman
Kodak 235, 250, and 300 copiers.
Heat dissipation
683 BTU per hour
408 BTU per hour
Binder on:
• 22,165 BTU per hour
• 14,185 BTU per hour with heat vent kits
Binder off:
• 21,265 BTU per hour
• 13,609 BTU per hour with heat vent kits
DocuTech 61xx Installation Planning Guide