Ordering Supplies For The Installation; Paper; Acceptable Paper Stocks And Sizes; Recommended Weight And Grade - Xerox DocuTech 6100 Install Manual

Select and prepare an installation site

Ordering supplies for the installation

Paper

4-26
You need to order consumable supplies (those that are depleted
during operation of the printer), such as paper, dry ink,
developer, fuser agent, stitcher wire, and binder tape. It is
important that you have an adequate supply on hand for
installation and that you maintain the supply after installation.
This section describes the supplies needed for installation. Your
sales representative will help you place your initial order for
supplies. The "Maintenance and support services" chapter
provides you with the information you need to order additional
supplies as you require them, a consumable supplies table, and
a supplies checklist.
You need to select your paper carefully. If you do not use the
proper paper, you increase the probability of paper jams and
misfeeds.

Acceptable paper stocks and sizes

Paper trays 1 and 2 accept 8.5 by 11 inch, 9 by 11 inch, 9 by 14
inch, and A4 (210 by 297 mm) cut sheet paper. Paper trays 3, 4,
and 5 accept paper up to 17 by 11 inches (432 by 279 mm).
You can use standard white, colored, pre-drilled, and preprinted
(letterhead and forms) paper, labels, and transparencies. The
stock you use must meet the specifications set forth by Xerox for
operability in the printer.
For additional information about paper specifications, refer to the
Xerox Document Services Platform Series DocuTech 61xx
Operator Guide.

Recommended weight and grade

Use a good quality, xerographic-grade paper. For best results,
use paper that is 20-pound or 75-grams per square meter (gsm)
bond, xerographic grade. Xerox 4024 Dual Purpose Paper
provides optimal performance in the printer. Refer to the
consumable supplies table in the "Maintenance and support
services" chapter.
Use paper within these parameters:
DocuTech 61xx Installation Planning Guide