Xerox DocuTech 6100 Install Manual page 38

Select and prepare an installation site
8a. The figure "Room temperature change (system replaced)" is used
to estimate the change in room temperature when the DocuTech is
added to a room. The figure is used to locate the appropriate change
in room BTU per hr. Refer to the appropriate room airflow rate. Then,
review the change that can be expected.
8b. Add the number from step 2 to the result from step 8a. Compare
the result with the maximum acceptable room temperature from step
3.
NOTE: If this temperature change causes the room temperature to
exceed the maximum acceptable room temperature, refer to the heat
management alternatives.
4-20
Table 4-10. Calculate the room temperature
Figure 4-1. Room temperature change
8a. Change in room
temperature _____ ° F or ° C
8b. Maximum temperature
plus change _____ ° F or ° C
DocuTech 61xx Installation Planning Guide