Before Scheduling Delivery Of The Docutech System; After Scheduling Delivery - Xerox DocuTech 6100 Install Manual

Before scheduling delivery of the DocuTech system

After scheduling delivery

DocuTech 61xx Installation Planning Guide
The following activities should be completed before you
schedule a delivery date for the DocuTech system:
• Select a location for the DocuTech system.
• Prepare the site:
– Install any required electrical service. Order Xerox
receptacle kits if required. Refer to the section, "Electrical
requirements", in chapter 3 for further information.
– Install any required Ethernet hardware.
– Complete the heat management worksheets included in
the section, "Heat management", in chapter 3. Perform
any modifications to the air handling capabilities of the
installation site based on the results of your assessment.
– Reserve a network address and hostname for each
DocuSP controller workstation.
• Identify networked client workstations that will submit jobs.
Ensure that the hardware, operating system, and network
protocols are supported by the DocuSP controller.
• Complete the Installation Worksheets from the Getting Ready
for the DocuSP Installation guide.
After the preceding activities are complete, schedule a delivery
date for the DocuTech hardware. This should be done with your
Xerox sales representative.
The following activities should begin at least two weeks prior to
the scheduled delivery date of the DocuTech system to your
location:
• Perform a final inspection of the installation site.
• Order the required consumable supplies that will be used
during the installation process. The minimum supplies
required during installation are:
– Paper, 2 cartons
– Developer, 1 carton
– Fuser agent, 2 cartons
– Binder tape and stitcher wire
Planning for the installation
3-3